Ips Netsim Delay-Us - Cisco MDS 9000 series Command Reference Manual

ips netsim delay-us

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ips netsim delay-us
To delay packets that arrive at a specified Gigabit Ethernet interface specifying microseconds, use the
ips netsim delay command in SAN extension tuner configuration submode.
Syntax Description delay-us microseconds
ingress
gigabitethernet
slot/port
Defaults
Disabled.
Command Modes SAN extension tuner configuration submode.
Command History Release
3.1(1)
Usage Guidelines
To use this command, you must enable the IP Network Simulator using the ips netsim enable command.
This command introduces a delay for all packets entering the Gigabit Ethernet interface. Delay is
unidirectional. To introduce delay in the opposite direction, use the slot and port number of the adjacent
interface.
Examples
The following example shows how to configure a delay of 50 microseconds for packets entering Gigabit
Ethernet interface 2/3.
switch# config terminal
switch(config)#
switch(config)# san-ext-tuner enable
switch(config)# exit
switch#
switch# ips netsim delay-us 50 ingress gigabitethernet 2/3
Related Commands Command
show ips netsim
ips netsim enable
Cisco MDS 9000 Family Command Reference
11-56
ips netsim delay-us microseconds ingress gigabitethernet slot/port
Specifies the delay in microseconds. The range is 0 to 150000.
Specifies the ingress direction.
Specifies the the slot and port number of the Gigabit Ethernet interface.
Modification
This command was introduced.
Description
Displays a summary of the interfaces that are currently operating in network
simulation mode.
Enables the IP Network Simulator.
Chapter 11 I Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x