Ivr Virtual-Fcdomain-Add - Cisco MDS 9000 series Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ivr virtual-fcdomain-add

To add the Inter-VSAN Routing (IVR) virtual domains in a specific VSAN(s) to the assigned domains
list in that VSAN, use the ivr virtual-fcdomain-add command. To delete the IVR virtual domains, use
the no form of the command.
Syntax Description vsan-ranges vsan-range
Defaults
Disabled.
Command Modes Configuration mode.
Command History Release
1.3(4)
Usage Guidelines
Use the no ivr virtual-fcdomain-add command to remove the currently active domains from the
fcdomain manager list in a specified VSAN.
Examples The following command adds the IVR virtual domains in VSAN 1.
switch# config terminal
switch(config)# ivr virtual-fcdomain-add vsan-ranges 1
The following command reverts to the factory default of not adding IVR virtual domains.
switch# config terminal
switch(config)# ivr virtual-fcdomain-add vsan-ranges 1
Related Commands Command
show ivr virtual-fcdomain-add-status
ivr withdraw domain
OL-8413-07, Cisco MDS SAN-OS Release 3.x
ivr virtual-fcdomain-add vsan-ranges vsan-range
no ivr virtual-fcdomain-add vsan-ranges vsan-range
Specifies the IVR VSANs or range of VSANs. The range of values for a
VSAN ID is 1 to 4093.
Modification
This command was introduced.
Description
Displays the configured VSAN topology for a fabric.
Removes overlapping domains.
Cisco MDS 9000 Family Command Reference
ivr virtual-fcdomain-add
11-133