Table of Contents
Advertisement
16
COOLING SYSTEM
16.5
Refilling with coolant
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
–
Place a suitable container under the water pump cover.
(All 125/150 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Drain plug, water pump cover
(125 XC‑W EU)
Drain plug, water pump cover
(150 XC‑W US)
V00373-11
(All 250/300 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump cover
V00374-11
(All 125/150 models)
–
Make sure that screw
–
Position the motorcycle upright.
–
Completely fill the radiator with coolant.
Coolant (
V00375-10
–
Loosen screw
–
Mount and tighten screw
Guideline
Bleeder screw, cylinder head
(125 XC‑W EU)
Bleeder screw, cylinder head
(150 XC‑W US)
V00377-10
. Take off radiator cap
with a new seal ring.
. Take off radiator cap
with a new seal ring.
is tightened.
p. 141)
and wait until coolant escapes without bubbles.
.
.
M6
8 Nm (5.9 lbf ft)
M6
8 Nm (5.9 lbf ft)
.
M6
10 Nm
(7.4 lbf ft)
M6
8 Nm (5.9 lbf ft)
M6
8 Nm (5.9 lbf ft)
101
Advertisement
Table of Contents
