Kyocera TASKalfa 420i Operation Manual page 91

Punch
Punch holes in sets of finished copies in preparation for binding.
NOTE:
Requires the optional 3,000 sheet document finisher and punching unit.
The orientations of the original and corresponding punch positions are as follows.
NOTE:
The inch model provides two-hole and three-hole punching. The metric model provides two-hole and
four-hole punching.
Follow the steps as below for punching.
OPERATION GUIDE
Downloaded from www.Manualslib.com
Original Copy
manuals search engine
Orientation of Original
Platen
1
Press the Copy key.
2
Place the originals on the platen.
3
Press [Org./Paper/Finishing]and then press
[Staple/Punch].
Basic Operation
Document
processor
3-19
3