Kyocera TASKalfa 420i Operation Manual page 85

Ready to copy.
Duplex
Place original.
Original : ---
Zoom :
100%
Paper : ---
Preview
Add Shortcut
Status
Collate/Offset Copying
The machine can collate and offset at the same time as it copies.
You can use the Collate/Offset copy function for tasks such as those shown below.
Collate
Offset
Without Document Finisher
OPERATION GUIDE
Downloaded from www.Manualslib.com
Original
1-sided
>>1-sided
1-sided
>>2-sided Binding Binding
Left/Right Top
2-sided
>>1-sided
2-sided
>>2-sided
Book
>>1-sided
Book
>>2-sided
Cancel
3 1
3
2 2
1
1 3
2
1
Original Copy
3
2
1
3
2
1
Original Copy (each set)
manuals search engine
6
If you choose [2-sided>>1-sided],
Copies
[2-sided>>2-sided], [Book>>1-sided] or
[Book>>2-sided], select the binding edge of the
originals of Original.
7
Press [Original Orientation] to select orientation of
the originals, either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
Top Edge Top
8
Press [OK].
Original
Orientation
OK
08/08/2009 10:10
9
Press the Start key.
Once an original placed on the platen is scanned,
replace it with the next one. Then, press the Start
key.
After scanning all originals, press [Finish Scan] to
start copying.
Scan multiple originals and deliver complete sets of
3
copies as required according to page number.
2
If the optional document finisher is not installed, when
you use offsetting, printed copies are produced after
rotating each set (or page) by 90º.
NOTE:
You need to load the same sized paper with
different orientation in the paper source other than the
3
2
selected paper source. The paper sizes supported in
1
Offset are A4, B5, Letter and 16K.
Basic Operation
3
3-13