Denso BHT-500B User Manual page 96

 "2: CONNECTOR": Connector communication environment
settings
1.
Select "2: CONNECTOR" at the SET COMMUNICATION menu and
then press the ENT key.
The SET CONNECTOR menu screen on the right displays.
2.
Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2]) to
highlight "1: PARAMETER" or "2: PROTOCOL", and then press the
ENT key.
Press and hold the BS/C key to return to the SET COMMUNICATION menu.
"1: PARAMETER": Setting the communication parameters
Select "1: PARAMETER" to display the screen shown on the right.
The highlighted settings will be the current settings.
"1: TRANSMIT SPEED":
"2: PARITY BIT":
"3: DATA BIT":
"4: STOP BIT":
To make changes, use the cursor keys ([▲] [▼]) or numerical keys ([1] [2]
[3] [4]) to highlight the item to be set, highlight the setting value using the
cursor keys ([◄] [►]), and then press the ENT key.
Press and hold the BS/C key to return to the SET CONNECTOR menu.
 Selecting the BHT-Ir protocol ignores the vertical parity, character length, and stop bit
- Point -
length settings.
 Selecting YMODEM requires the vertical parity, character length, and stop bit length to be
set to N, 8 and 1, respectively.
Sets the transmission speed.
Sets the vertical parity: none, odd, or even.
Sets the character length.
Sets the stop bit length.
Barcode Handy Terminal
79