Denso BHT-500B User Manual page 142

4.
Use the cursor keys ([▲] [▼]) or numerical keys ([2]
hi ghlight a WEP KEY from 1 to 4, and then press the ENT key.
The screen on the right displays.
[1: KEY SIZE]:
Select 40 (40 bits) or 128 (128 bit).
The highlighted setting is the current setting.
When no encryption ke
[2 : KEY]:
If the encryption key has been set, the key size "*" displays.
When no encryption key has been set, this
5.
Use the cursor keys ([▲] [▼]) or numeric
cu rsor keys ([◄] [►]) to select either 40 (40 bit
S elect 40 bit for a 10-digit encryption key.
Select 128 bit for a 26-digit encryption key.
6.
Use the cursor keys ([▲] [▼]) or numerical key ([2]) to highlight [2:
ENT key.
The mode changes to entry mode
7.
Use the numerical keys
the ENT key.
Hexadecimal notation (0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F) is used for
the encryption key.
P ress the SF key to change
d isplay) and alphabet entry).
To delete a single character, press the BS/C key.
Press and hold the BS/C key to delete all entries made.
The existing key can be overwritten, however, cannot be edited or deleted.
The screen on the right shows an example in which "40 bit" has been set
for "WEP KEY1" and the key setting is "ABCDE12345".
y has been set, 40 will be highlighted.
field is empty.
al key ([1]) to hi
) or 128 (128 bit).
and the cursor displays.
to enter an encryption key and then press
the entry mode (numerical entry (no guidanc
Barcode Handy Terminal
[3] [4] [5]) to
ghlight [1: KEY SIZE], and then use the
KEY], and then press the
e
125