PROPELLER SHAFT
4E-5
INSPECTION
No periodic inspection of propeller shaft assembly is re-
quired.
MINOR SERVICES AND REPAIRS
ALIGNMENT OF ENGINE A N D PROPELLER SHAFT
All necessary differential pinion angle requirements are
designed and built into rear upper and lower control arm
geometry. Slots in the engine support rear crossmember
provide for fore and aft movement of engine-transmission
assembly to provide for minor variation in positioning.
MAJOR REPAIRS
REMOVE PROPELLER SHAFT
CAUTION: Use care not to crush exhaust sys-
tem 'jcick-underVpipe on B Series station wag-
ons when using an axle engaging hoist.
1. Mark propeller shaft rear yoke (single cardon joint)
or universal joint flange (double cardon joint) and
COUPES
SEDANS
STAT I ON WAGONS
Fig. 4E-4 Propeller Shaft Installation
-
B Series