Pontiac FIREBIRD 1972 Service Manual page 976

TURBO HYDRA-MATIC (M-40) TRANSMISSION 7E-87
Fig. 7E-189 Installing Front Band
End play should be from .007"-.019". The selec-
tive washer controlling this end play is a steel
washer having 3 lugs and is located between
thrust washer and rear face of transmission case.
If a different washer thickness is required to bring
end play within specifications, it can be selected from
the chart under REAR END PLAY CHECKING
PROCEDURE.
17. Install front band with anchor hole placed over band
anchor pin and apply lug facing serbo hole (Fig. 7E-
189).
L
I
Fig. 7E-190 Positioning Actuator Rod Plunger
/
. ,
a
I
-..
.
.
Fig. 7E-191 Installing J a m N u t onto Manual Shaft
18. Install manual linkage as follows:
a. If necessary, install a new manual shaft seal into
transmission case, using a 3/4" dia. rod to seat the
seal.
b. If removed, insert actuator rod into manual de-
tent lever from side opposite pin.
c. Install actuator rod plunger under parking
bracket and over parking pawl (Fig. 7E-190).
d. Install manual shaft through case and detent
lever.
e. Install detent retaining hex lock nut on manual
shaft and tighten to 20 lb. ft. (Fig. 7E-191).
f. Install retaining pin, indexing with groove in
Fig. 7E-192 Installing Direct Clutch Assembly