Pontiac FIREBIRD 1972 Service Manual page 984

7E-94 1972 PONTIAC SERVICE MANUAL
I
MODULATOR VALVE
3. Install vacuum modulator into case (Fig. 7E-214).
0 -RING SEAL
I
L
VACUUM MODULATOR
Fig. 7E-214 Installing Vacuum Modulator
NOTE: After any major repair, the flter must
be replaced and oil cooler and cooler lines must
be flushed.
3. Install new bottom pan gasket and bottom pan with
attaching screws. Torque to 12 Ib. ft.
MODULATOR VALVE AND VACUUM
MODULATOR
INSTALL
1. Install modulator valve into case, stem end out.
2. Install O-ring seal on vacuum modulator
Fig. 7E-2 15 Installing Governor
4. Install modulator retainer and attaching bolt. Torque
bolt to 18 lb. ft.
GOVERNOR
INSTALL
1. Install governor into case (Fig. 7E-215).
2. Attach governor cover and new gasket with four (4)
attaching bolts. Torque bolts to 18 Ib. ft.
SPEEDOMETER DRIVEN GEAR-SPEED
CONTROL SWITCH
INSTALL
1. Install speedometer driven gear-speed control switch
assembly into case extension.
2. Install speedometer driven gear-speed control switch
retainer and attaching bolt.
CONVERTER ASSEMBLY
INSTALL
With the transmission in cradle or portable jack, install
the converter assembly into the pump assembly, making
certain that the converter hub drive slots are fully engaged
with the pump drive gear tangs and the converter installed
fully towards the rear of the transmission.
TRANSMISSION ASSEMBLY
INSTALL
Reverse the procedure for transmission removal as stated
under REMOVAL O F TRANSMISSION.
MANUAL LINKAGE
-
ADJUST
Manual linkage adjustment and the associated neutral
safety switch are important from a safety stand point. The
neutral safety switch should be adjusted so that the engine
will start in the Park and Neutral positions only.
With the selector lever in the Park position, the parking
pawl should freely engage and prevent the vehicle from
rolling. The pointer oi the indicator quadrant should line
up properly with the range indicators in all ranges.