Pontiac FIREBIRD 1972 Service Manual page 972

TURBO HYDRA-MATIC (M-40) TRANSMISSION 7E-83
THR
BEA
Fig. 7E-172 lnstalling Bearing and Races on Sun Gear
Shaft
15. Install center support-to-sun gear thrust races and
bearings, retaining with petrolatum, as follows:
a. Install large race, center flange up over sun gear
shaft.
b. Install thrust bearing against race.
c. Install second race, center flange up (Fig. 7E-
172).
16. Install rollers that may have come out of the roller
cage by compressing the energizing spring with fore-
finger and inserting roller from the outer side (Fig.
7E-173).
17. Install roller clutch into reaction carrier outer race
(Fig. 7E-174).
Fig. 7E-174 lnstalling Roller Clutch Assembly
18. Install center support-to-reaction carrier thrust
washer into recess in center support. Retain with
petrolatum (Fig. 7E- 175).
19. Install center support into reaction carrier and roller
clutch assembly (Fig. 7E-176).
NOTE: With reaction carrier he& center sup-
port should only turn counterclockwise.
20. Install J 21795 on gear unit to hold units in place.
21. Install output shaft-to-case thrust washer tabs in
pockets and retain with petrolatum (Fig. 7E-177).
ASSEMBLY OF UNITS INTO
TRANSMISSION CASE
NOTE: The first 3 steps can be omitted i f the
Fig. 7E-173 lnstalling Roller into Roller Clutch
Fig. 7E-175 lnstalling Center Support Thrust Washer