Pontiac FIREBIRD 1972 Service Manual page 571

V-8 ENGINE 6-59
Fig. 6-97 Engine Lifting Tools Installed
-
V-8 A Series
7. Replace two front motor mount to frame bolts.
8. For remaining installation procedures, reverse steps
1 thru 16.
Fig. 6-98 Engine Lifting Tools Installed
-
V-8 F Series
Fig. 6-99 Engine Lifting Tools Installed
-
V-8 X Series
MANIFOLD
-
VALVE TRAIN
-
CYLINDER
HEADS
RIGHT SIDE EXHAUST MANIFOLD OR
GASKET
REMOVE
307 Engine
-
Disconnect battery ground cable.
307 Engine
-
Remove air cleaner pre-heater stove.
Disconnect exhaust pipe from manifold.
Straighten tabs on manifold front and rear individual
bolt locks and remove manifold attaching bolts,
manifold, and gaskets. (Locks are used on front and
rear pairs of bolts only on all except 307 engines).
REPLACE
1. Thoroughly clean gasket surfaces of cylinder head
and exhaust manifold.
2. Replace exhaust manifold and new gasket. Use new
individual manifold bolt locks on front and rear pairs
.
of bolts on all but 307 engines.
3. Place manifold outlet in position over end of exhaust
pipe but do not permit weight of manifold to rest on
exhaust pipe. Since the end holes of gasket are slotted,