TURBO HYDRA-MATIC (M-40) TRANSMISSION
7E-8 1
SNAP
R I N G
SPEEDOMETER
DRIVE GEAR
1.D. FLANGE
O.D. FLANGE
0- R I N G
1
SUN 'GEAR
I.D. FLANGE
SHAFT
RACE
c. Place second race on bearing, with outer flange
Fig. 7E-165 Exploded View of Rear Unit
8. Install output shaft-to-output carrier snap ring.
1
Fig. 7E-166 Installing Mainshaft Snap Ring
9. Turn assembly over and support so that output shaft
hangs downward.
10. Install reaction carrier-to-output carrier thrust
washer, with tabs facing down in pockets and retain
with petrolatum.
11. Install sun gear, splines with chamfer down.
THRUST BEARING
Fig. 7E-167 Installing Bearing and Races