Superheat Shut-Off Switch - Pontiac FIREBIRD 1972 Service Manual

CUSTOM AIR CONDITIONING
1A-85
Fig. 1 A - 1 0 2 Seating Seal Seat Retainer
13. Install new absorbent sleeve by rolling the material
into a cylinder, overlapping the ends and slipping
sleeve into compressor neck with overlap toward the
top of the compressor. With a small screwdriver or
similar instrument, carefully spread sleeve to remove
overlap so that in final position ends of sleeve will
butt at top vertical centerline.
14. Position new metal sleeve retainer so tbqt its flange
face will be against the front end of the sleeve. Tool
J 9395 or the sleeve from tool J 9393 may be used to
install the retainer. press and tap with a mallet, set-
ting the retainer and sleeve into place, until the outer
edge of the retainer is recessed approximately 1/32"
from the face of the compressor neck.
15. Reinstall the clutch driven plate.
SUPERHEAT SHUT-OFF SWITCH
11. Leak test compressor using a propane torch type (or
electronic) leak detector, in good condition. Correct
REMOVE AND REPLACE
any leaks found.
12. Wive out any excess oil inside compressor neck and
1. Disconnect electrical connector from thermal limiter
- -
onshaft, resulting from installing new seal parts.
assembly.
SWITCH
TERMINAL
TERMINAL HOUSING
RETAINER
RING
RETAINER RING
O-RING SEAL
SUPERHEAT
SHUTOFF
SWITCH
REAR HEAD
Fig. 1 A - 1 0 2 A Cross Sectional View
-
Superheat Shut-Off Switch in Rear Head