Pontiac FIREBIRD 1972 Service Manual page 167

1972 PONTIAC SERVICE MANUAL
Fig. 1A-131 A/C Heater Cable Routing
-
X Series
4. If door is not heard seating or if lever is more than
1/8 inch from end of slot, repeat steps 2 and 3 until
cable is properly adjusted. See Fig. 1A-126 for cable
installation and routing.
A/C CONTROL PANEL
REMOVE AND REPLACE
-
A AND G SERIES
1. Disconnect battery.
2. Remove cold air duct.
3. Remove radio.
4. Remove electrical and vacuum connections at con-
trol panel. NOTE: Identify wire connectors to swit-
ches and vacuum connectors for correct reassembly.
5. Remove control panel retaining screws (nuts on A
Series).
6. Lower control panel assembly.
7. Disconnect temperature control cable and remove
control.
8. TO replace, reverse removal procedure. See installa-
tion of control panels on Figs. 1 A- 124 (G Series) and
1A-125 (A Series).
REMOVE A N D REPLACE
-
B A N D F SERIES
1. Disconnect battery.
2. Remove steering column trim.
3. Remove instrument panel trim plate (at cluster).
4. On F Series, remove rally gage cluster (fuel, volts) if
applicable.
5. Remove glove compartment and door
6 . Disconnect temperature cable at heater case.
7. Remove control panel retaining screws.
8.
is connect
vacuum connectors at control (See Figs.
1A-123 and 1A-126).
9. On F Series, remove rear control panel retaining
screw at radio support.
10. Remove control from instrument panel, disconnect-