Pontiac FIREBIRD 1972 Service Manual page 955

7E-66 1972 PONTIAC SERVICE MANUAL
Fig. 7E-123 Air Checking Forward Clutch
clutch plates, starting with the waved steel and
alternating composition and flat steel clutch
plates (Fig. 7E- 122).
c. (Model P D Only) Oil and install four (4) compo-
sition, three (3) flat steel and one (1) waved steel
clutch plates, starting with the waved steel and
alternating composition and flat steel clutch
plates (Fig. 7E- 122).
NOTE: Radially grooved composition clutch
plates are installed at the factory only. All ser-
vice composition plates have the smooth sur-
face configuration.
SNAP RING
CLUTCH
\
DIRECT CLUTCH BACKING PLATE I " "
DIRECT CLUTCH
HOUSING
Fig. 7E-125 Removing or Installing Backing Plate Snap
Ring
CAUTION: Do not confuse the flat steel plate
@fate with " V notch) with the waved steel
clutch plate (pate with " U notch).
11. Install direct clutch hub and retaining snap ring (Fig.
7E-114).
12. Place forward clutch housing on pump delivery
sleeve and air check clutch operation (Fig. 7E-123).
DIRECT CLUTCH AND INTERMEDIATE
SPRAG
DISASSEMBLE
1. Remove intermediate clutch retainer snap ring and
retainer (Fig. 7E- 124).
p R , N
\
F L A T ~ T E E L PLATES
DlRECT CLUTCH BACKING PLATE
Fig. 7E-124 Removing or Installing Clutch Retainer Snap
Ring
Fig. 7E-126 Exploded View of Direct Clutch Pack