Pontiac FIREBIRD 1972 Service Manual page 952

TURBO HYDRA-MATIC (M-40) TRANSMISSION 7E-63
3. Install spacer(s) if used, retainer and spring into pres-
sure regulator bore (Fig. 7E-108).
4. Install pressure regulator valve from opposite end of
bore, stem end first.
5. Install boost valve into bushing, stem end out, and
install both parts into pump cover by compressing
bushing against spring.
6. Install retaining snap ring.
7. Install pressure regulator valve bore plug and retain-
ing pin into opposite end of bore.
8. Install previously selected front unit selective thrust
washer over pump cover delivery sleeve.
9. Install two (2) hook-type oil seal rings.
10. Assembly pump cover to pump body with attaching
bolts.
NOTE: Leave bolts one turn loose at this time.
1 1. Place Pump Aligning Strap J 2 1368 over pump body
and cover and tighten tool (Fig. 7E-112).
12. Tighten pump cover bolts (18 lb. ft. torque).
13. Install and align pump-to-case gasket.
14. Install pump-to-case O-ring seal.
FORWARD CLUTCH
DISASSEMBLE
Fig. 7 E - 1 1 4 Removing or Installing Clutch Hub Retaining
Snap Ring
'
FORWARD
CLUTCH HUB
'
4 4
FORWARD
CLUTCH
HOUSING
Fig. 7E-1 1 5
Removing or Installing Forward Clutch Hub
1. Place forward clutch and turbine shaft in hole in
bench or Holding Fixture J 61 16 and remove forward
clutch housing-to-direct clutch hub snap ring (Fig.
7E- 1 14).
2. Remove direct clutch hub.
3. Remove forward clutch hub and thrust washers (Fig.
7E- 1 15).
4. Remove composition and steel clutch plates from the
forward clutch housing.
5. Place forward clutch and turbine shaft in arbor press
and press out turbine shaft (Fig. 7E-116).
SHAFT
Fig. 7E-1 16 Pressing Turbine Shaft From Clutch Housing