Pontiac FIREBIRD 1972 Service Manual page 935

1972 PONTIAC SERVICE MANUAL
clutch housing. If more or less washer thickness is
required to bring end play within specifications, se-
lect proper washer from the following chart:
Thickness
.060-.064"
.07 1-.075"
.082-.086"
.093-.097"
.104-. 108"
.115-.119"
126-. 130"
Color
Yellow
Blue
Red
Brown
Green
Black
Purple
NOTE: An oil soaked washer may tend to dis-
cofoc so it will be necessary to measure washer
for its actual thickness.
GASKET
'
I
OIL PUMP
Fig. 7E-57 Case Extension and Gasket
REMOVE
1. If necessary to replace, pry front seal from pump
(Fig. 7E-59).
2. Remove pump attaching bolts.
3. Install 3/8"-16 threaded Slide Hammer Adapters J
6125-2 into bolt holes in pump body, attach Slide
Hammers J 6125-1 and remove pump assembly from
case (See Fig. 7E-60 for location of threaded holes).
4. Remove and discard pump-to-case seal ring and gas-
ket.
5. Remove forward clutch assembly and turbine shaft
from transmission (Fig. 7E-6 1).
Fig. 7E-58 Checking Front End Play
4. Push turbine shaft rearward.
5. Push output shaft forward.
6. Set dial indicator to Zero.
7. Pull turbine shaft forward.
8. Read resulting travel (or end play). Should be .003"-
.024".
9. Selective washer controlling this end play is the
washer located between pump cover and forward
Fig. 7E-59 Removing Front Seal