Table of Contents
Advertisement
Figure 55. Removing the PDB
Next steps
Replace the
PDB.
Installing the power distribution board
Prerequisites
WARNING:
Allow the power distribution board (PDB) to discharge after you power off the system. Handle the
PDB by the edges and avoid touching the contact surfaces of the connectors.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the power supply
4. Disconnect the cables that are connected to PDB expect for the mid-plane power cables.
Steps
1. Align and insert the PDB on the connector on the chassis.
2. Using the Phillips 2 screwdriver, tighten the screws to secure the PDB to the chassis.
Safety
instructions.
Before working inside your
units.
system.
Installing and removing system components
57
Advertisement
Table of Contents
