Power distribution board
This is a service technician replaceable part only.
Removing the 2U power distribution board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the M.2 direct
5.
Remove the side
cover.
6.
Remove the Riser
1.
7. Disconnect the cables connected from cooling fans and system board to the 2U power distribution board (PDB).
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the PDB to the system.
Figure 49. Removing the 2U power distribution board
2. Lift the board to remove it from the system.
Next steps
Replace the power distribution
Installing the 2U power distribution board
Prerequisites
1. Follow the safety guidelines listed in
78
Installing and removing system components
Safety
instructions.
Before working inside your
riser.
board.
Safety
instructions.
system.