Auto Sleep Time - Canon imagerunner advance C5550i User Manual

If you set this function to <On>, general users become unable to set <Auto Reset Time> and <Function After
Auto Reset>.
<Function After Auto Reset>
<Preferences> <Timer/Energy Settings>
You can set whether the default screen set for <Default Screen after Startup/Restoration> in <Preferences> or
the immediately previous screen is displayed at startup after the Auto Reset initiates.
● If you select <Initial Function>, the screen set in <Default Screen after Startup/Restoration> is
displayed when the Auto Reset initiates. If you select <Selected Function>, the Basic Features screen
for the function you were using is displayed again.
<Auto Sleep Time>
<Preferences> <Timer/Energy Settings>
You can set the time until the machine automatically enters the Sleep mode if no operations are performed.
● It is recommended that the default value is used for this setting.
<Sleep Mode Energy Use>
<Preferences> <Timer/Energy Settings>
You can set the amount of energy that the machine consumes when it is in the Sleep mode.
● If the machine is connected to a computer using a USB cable, depending on the timing for entering
the sleep mode, the machine may be unable to receive data correctly. Reactivate the machine from
the sleep mode, then execute the job again.
● The energy consumption level may be the same as when <High> is set even when <Low> is set,
depending on the status of the machine.
● When performing wireless communication while <Sleep Mode Energy Use> is set to <Low>, and
<Wireless LAN Settings> or <Use Bluetooth> is enabled, <Compensate for Network Comm.> changes
to <On>.
● If the energy consumption level is set to <Low>, communication failure may occur, depending on the
network utility software you are using. To avoid this, press the Energy Saver key to cancel the Sleep
mode before using the machine.
Settings/Registration
739