Setting a manual address
1
Press <Manual Address Settings>.
2
Press <On> in <Use Manual Address> and carry out the necessary settings.
<Use Manual Address>
Press <On>.
<Manual Address>
Press the <Manual Address> button and enter an address. The following addresses cannot be used.
●
Addresses that begin with "ff" (multicast address)
●
Addresses that consist only of "0"
●
IPv4-compatible addresses (IPv6 addresses in which the upper 96 bits are "0" with an IPv4 address
contained in the lower 32 bits)
●
IPv4-mapped addresses (IPv6 addresses in which the upper 96 bits are "0:0:0:0:ffff:" with an IPv4
address contained in the lower 32 bits)
<Prefix Length>
The length of the network address section can be changed.
<Default Router Address>
Press <Default Router Address> and enter an address. The following addresses cannot be used.
●
Addresses that begin with "ff" (multicast address).
●
Addresses that consist only of "0"
If you don't specify an address, leave the column blank.
Setting a stateful address
1
Press <Use DHCPv6>.
2
Press <On>
<OK>.
Setting Up
36