Setting An Ipv4 Address - Canon imagerunner advance C5550i User Manual

Hide thumbs Also See for imagerunner advance C5550i:

Table of Contents

Setting an IPv4 Address

There are two methods to set an IPv4 address: allocating automatically using DHCP and entering manually. Select

either of the two according to your environment. Conduct a connection test as necessary.

Setting an IPv4 Address(P. 33)

Conducting a Connection Test for an IPv4 Address(P. 34)

Press <Preferences>

Press <Use IPv4>

Press <IP Address Settings> and set an IP address.

You can set both automatic allocation and manual allocation. This enables you to use the IP address entered

manually if automatic acquisition of an IP address fails.

Automatic allocation using DHCP

Press <DHCP> or <Auto IP>. Select one of them according to your network environment. If you select both

<DHCP> and <Auto IP>, automatic allocation using DHCP takes priority.

If you press <Auto IP>, the available IP address is automatically searched in the network (LAN) and the

value for each item is allocated. This function allocates the IP address without using a DHCP server.

However, communication outside of the router range is not available.

In an environment where both <DHCP> and <Auto IP> cannot be used, if either of the two is selected,

useless communication occurs because the machine tries to check if the service is provided on the

Setting by manual entry

Confirm that both <DHCP> and <Auto IP> are canceled.

If either of the two is selected, press the button to cancel.

<OK> to enable IPv4 settings.

<IPv4 Settings>.