Canon imagerunner advance C5550i User Manual page 22

Setting Up
● Press <On> for <Use IPv4> or <Use IPv6>, and press <Next>. You can also use both
IPv4 and IPv6.
● If you press <Off> for <Use IPv4> and <Use IPv6>, and press <OK>, skip the network
settings and proceed to Step 9.
If you press <On> for <Use IPv4>, specify the following settings.
● To obtain the IP address automatically, press <DHCP> or <Auto IP>, and press
<Next> or <OK>.
● To set the IP address manually, clear the selection for <DHCP> or <Auto IP>, press
<IP Address>, <Subnet Mask>, and <Gateway Address> to enter each value, and
press <Next> or <OK>.
● For information on the IPV4 address settings, see
Address(P. 33) .
If you press <On> for <Use IPv6>, specify the following settings.
● Press <On> to use the stateless address or <Off> to not use the stateless address,
and press <Next>.
● For information on the IPv6 address, see
After specifying the stateless address, specify the following settings.
Setting an IPv6 Address(P. 35) .
10
Setting an IPv4