Moving To Run Mode - Omron FQ2-S/CH Series User Manual

Moving to Run Mode

You can move from Setup Mode to Run Mode by using the following procedure.
1
Press [Run].
2
Press [Switch to Run mode.].
3
Press [Yes].
If you press [No], the setting will not be saved
and you will move to Run Mode.
Note
• Returning to Setup Mode
Press and press [Sensor settings].
• Signal Status When Moving to Run Mode
When moving to Run Mode, the signal will change as shown below and data can be input from and output to an
external device.
BUSY signal
FQ2-S/CH User's Manual
Display Setup Mode
ON
OFF
Run Mode
The BUSY signal that was
always ON will turn OFF.
Starting Operation
353