Display Elements - Omron FQ2-S/CH Series User Manual

4
When the Sensor is detected, the following display will appear.
• The Setup Mode will appear if a Sensor that has not been
set up is connected.
• The Run Mode will appear if a Sensor that has been set
up is connected.
Note
When the Touch Finder is started, IP addresses are automatically set for each Sensor.
To allocate specific IP addresses, set the IP address of each Sensor and the Touch Finder.
2-6 Setting Up Ethernet: p.67

Display Elements

This Sensor has a Setup Mode and a Run Mode.
Refer to 9-1 Menu Tables: p. 438
30
Startup Display and Display Elements FQ2-S/CH User's Manual