Setting The Calibration Pattern - Omron FQ2-S/CH Series User Manual

Setting the Calibration Pattern

Point Specification
Set the pixel coordinates of positions to set the calibration pattern.
When you enter the actual coordinates of the specified positions, the calibration parameters are automatically
calculated.
You can register the coordinates of up to nine positions.
• Different Magnifications in X and Y Directions
Specify three positions.
X : Y = 5 : 3
Note
Calibration cannot be performed using two places. Specify at least three places.
(Setup Mode) − [Calibration]
1
Select the data region to set from [Calibration
data 0] to [Calibration data 31].
2
Press [Modify].
3
[ ] −
Press [Specify point] on the right of the
display.
FQ2-S/CH User's Manual
X : Y = 1 : 1
Calibration
371
Calibration