Setting The Retry Function; Retry Function - Omron FQ2-S/CH Series User Manual

7-11Setting the Retry Function

FQ2-S4 FQ2-CH

Retry Function

This function repeats the Scan (with a single measurement trigger) until the overall judgment is OK.
The retry function has four modes: normal retry, exposure retry (*1), scene retry, and trigger retry.
*1: The brightness (exposure) depends on the shutter speed and gain. When HDR is ON, the shutter speed and gain are automatically
adjusted for the optimum exposure. When HDR is OFF, the gain is fixed.
(Setup Mode) − [Sensor settings] − [Retry details] − [Retry mode]
1
Select the retry mode.
Retry mode
Normal retry
Exposure retry
Scene retry
Trigger retry
None (Default)
422
Setting the Retry Function
This function repeats the Scan at the specified interval and count until the overall judg-
ment is OK.
Sets the repeat count and imaging interval.
These settings are set from Retry settings of each Scenes.
Scanning is repeated the specified number of times while varying the exposure (when
HDR is OFF, the shutter speed is varied) until the entire code is successfully scanned.
The brightness step (shutter speed step when HDR is OFF), increment count, and decre-
ment count are specified. The settings are configured in the retry settings of each scene.
This function repeats the scan at the specified count while switching the Scenes until the
overall judgment is OK.
[Auto] or [Fixed] is selected for the switch order.
[Auto]: Switches through the scenes in the order of highest frequency of use.
[Fixed]: Switches scenes in the set order.
This function repeats the reading procedure until the overall judgment is OK when IN5
signal of parallel is ON.
To use trigger retry, the I/O input mode must be set to expanded mode.
Retry is not performed.
Description
FQ2-S/CH User's Manual