Before You Start; Connecting The Sp-404Sx To Your Speakers - Roland sp-404sx Owner's Manual

Before You Start

Connecting the SP-404SX to Your Speakers

Make sure that the SP-404SX and your amplified speakers (which we'll simply call "speakers") are powered off, and then make
connections as shown below.
Amplified speakers
(sold separately)
NOTE
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power
on all devices before making any connections.
About Functional Ground Terminal
Depending on the circumstances of a particular setup, you may experience a discomforting sensation, or perceive that the
surface feels gritty to the touch when you touch this device, mics connected to it, or the metal portions of other objects.
This is due to an infinitesimal electrical charge, which is absolutely harmless. However, if you are concerned about this,
connect the ground terminal (see figure) with an external ground. When the unit is grounded, a slight hum may occur,
depending on the particulars of your installation. If you are unsure of the connection method, contact the nearest Roland
Service Center, or an authorized Roland distributor, as listed on the "Information" page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of lightning)
8
Audio cables
(sold separately)
LINE IN jacks
AC adaptor
LINE OUT jacks
If you're using headphones
(sold separately), connect them
here.
Place the AC adaptor so the side with
the indicator (see illustration) faces
upwards and the side with textual
information faces downwards.
The indicator will light when you plug
the AC adaptor into an AC outlet.
DC IN jack