Baud Rate - Kyocera Mita FS-1050 Operation Manual

Using the Operator Panel
5
Press the ENTER key again.
6
Press the > key. Each time the
item and current setting change as shown below.
>Baud Rate
9600
>Data Bits
8
>Stop Bits
1
>Parity
None
>Protocol
DTR(pos.)&XON
7
Display the setting item to be changed and press the ENTER key. A
question mark (?) appears.
The following example shows how to change the baud rate. The
settings for other items can be changed in a similar manner.
>Baud Rate
? 9600
8
Press the
changes as shown below.
The baud rate can be selected from 1200, 2400, 4800, 9600
(default), 19200, 38400, 57600, and 115200.
Some computers may not be compatible with a baud rate of 115200 bps.
If you set the baud rate to 115200 and communication problems occur,
lower the baud rate.
Note
Definable baud rates: 1200, 2400,
4800, 9600 (default), 19200, 38400,
57600, 115200
Definable data bits: 7, 8 (default)
Definable stop bits: 1 (default), 2
Definable parity: None (default), Odd,
Even, Ignore
Definable protocol: DTR(pos.)&XON
(default), DTR(positive), DTR
(negative), XON/XOFF, ETX/ACK
or key to display the desired setting. The setting
1-20
or key is pressed, the setting