Baud Rate; Data Bits; Stop Bits - Kyocera Mita FS-C5016N Operation Manual

3.5 Changing the Interface Parameters
Pressing the or
the serial parameter, press the ENTER key. Use the
or selection.
>Baud Rate
9600
>Data Bits
8
>Stop Bits
1
>Parity
None
>Protocol
DTR(pos.)&XON
For example, to change baud rate from 9600 to 115200, display the baud rate
menu following the above procedure. When the display shows baud rate, 9600
(bps), press the ENTER key. A blinking question mark (?) appears.
>Baud Rate
? 9600
Press the or key to scroll through values. When 115200 is displayed, press the
ENTER key. Press the MODE key to exit the menu selection.
Some computers may not be able to handle a baud rate of 115200 bps. If you
set the baud rate to 115200 and encounter communication problems, select
a lower baud rate.
Note
key toggles through the serial parameters as follows. To change
Range
1200 , 2400
38400 , 57600
7 or 8 (Default)
1 (Default) or
None
(Default),
DTR(pos.)& Xon
DTR
(negative),
3-36
or key to change the value
, 4800 , 9600 (Default), 19200
, 115200
2
Odd Even Ignore
, , or
DTR
(Default),
(positive),
XON/XOFF ETX/ACK
, or
,