Table of Contents
Advertisement
4
Press the
Interface
? USB
If you want to abandon this procedure, press the CANCEL key. The
interface remains unchanged.
5
Press the ENTER key.
6
Press the MENU key. The message display returns to Ready.
Selecting the Serial Interface Mode
This section applies to the printers having the optional serial interface
board installed.
Option
You can set the baud rate, data bits, stop bits, parity and the protocol for
the serial interface.
1
Press the MENU key.
2
Press the
interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Serial (option)
Option (with a network interface card installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If you want to abandon this procedure, press the CANCEL key. The
interface remains unchanged.
4
Press the
Interface
? Serial
or
key until USB appears.
or
key until Interface > appears. One of the
or
key until Serial appears.
1-19
Using the Operator Panel
Advertisement
Table of Contents
