Table of Contents
Advertisement
Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery time for Auto
Continue.
1
Press the MENU key.
2
Press the
or
Others
3
Press the > key.
4
Press the
or
>Auto Continue >
Mode
On
5
Press the > key and display >>Auto Continue Timer.
6
Press the ENTER key. A blinking cursor (_) appears.
>>Auto Continue
Timer
7
Press the
or
where the cursor is blinking and set the desired time. The time must
be set between 000 and 495 seconds, in 5-second increments. If set to
000 , printing will be continued immediately without allowing any
time interval. You can use the > and < keys to move the cursor right
and left.
If you want to abandon the selection, press the CANCEL key.
8
Display the desired time and press the ENTER key.
9
Press the MENU key. The message display returns to Ready.
key until Others > appears.
>
key until >Auto Continue > appears.
030Sec.
key to increase or decrease the value of the figure
1-85
Using the Operator Panel
Advertisement
Table of Contents
