Table of Contents
Advertisement
Using the Operator Panel
8
Press the > key.
9
Press the
or
measurement can be selected between millimeters and inches. The
current unit of measurement is displayed (the default setting is mm ).
>>Unit
mm
10
Press the ENTER key. A blinking question mark (?) appears.
>>Unit
? mm
11
Select mm or inch using the
If you want to abandon the selection, press the CANCEL key.
12
Press the ENTER key.
13
When the unit of measurement is set, press the
Dimension appears as shown below (the paper width setting).
>>X Dimension
14
Press the ENTER key. A blinking cursor (_) appears.
>>X Dimension
15
Press the
or
where the cursor is blinking and display the desired width. The
width can be set between 148 and 216 mm (5.83 to 8.5 inches). You
can use the > and < keys to move the cursor right and left.
If you want to abandon the selection, press the CANCEL key.
16
Display the desired paper width and press the ENTER key.
key until >>Unit appears. The unit of
or
210 mm
210 mm
key to increase or decrease the value of the figure
1-64
key.
key. >>X
Advertisement
Table of Contents
