Table of Contents
Advertisement
Protecting Resources
When you switch from the PCL 6 emulation to another, all downloaded
fonts and macros are lost. Resource protection preserves these PCL
resources in memory so that they are intact when you change the
emulation back to PCL 6.
Resource protection requires extra memory to store downloaded fonts
and macros. The total size of the printer memory recommended for using
the resource protection function is affected by several factors.
Note
1
Press the MENU key.
2
Press the
Others
3
Press the > key.
4
Press the
>Resouce Prot.
Off
5
Press the ENTER key. A blinking question mark (?) appears.
>Resouce Prot.
? Off
6
Press the
changes as shown below.
Off (default)
Permanent
Perm / Temp
If you want to abondon this procedure, press the CANCEL key.
7
When the desired mode is displayed, press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
or
key until Others > appears.
>
or
key until >Resouce Prot. appears.
or
key to display the desired mode. The display
1-83
Using the Operator Panel
Advertisement
Table of Contents
