Kyocera Mita FS-1050 Operation Manual page 85

Resetting the Remaining Toner Counter
If the toner container was replaced, reset the toner counter as follows so
that an accurate toner gauge measurement is indicated on the status page.
Note that if this operation is performed when the toner cartridge is not
replaced, the toner gauge measurement will not be indicated correctly.
Installation Guide Installation Guide
Also refer to the Installation Guide Installation Guide
replacing the toner container.
1
Press the MENU key.
2
Press the or
Life Counters
3
Press the > key.
4
Press the or
>New Toner
Installed
5
Press the ENTER key. A question mark (?) appears.
>New Toner
Installed ?
6
Press the ENTER key. The toner counter is reset, and the message
display returns to Ready.
supplied with the toner kit when
key until Life Counters > appears.
>
key until >New Toner Installed appears.
1-75
Using the Operator Panel