Table of Contents
Advertisement
Programming the LDAP server
This section describes how to specify the LDAP server settings.
This function supports LDAP version 2.0 and 3.0.
Program the LDAP server to find user information in the LDAP server Address Book directly.
To start an LDAP search, make sure that the items listed below are set. For other items, check your
environment and make any necessary changes.
• Name
• Server Name
• Search Base
• Port Number
• Use Secure Connection (SSL)
• Authentication
• Search Conditions
Programming the LDAP server
This section describes how to program the LDAP server.
1.
Press [System Settings].
2.
Press [Administrator Tools].
3.
Press [ Next] twice.
4.
Press [Program / Change / Delete LDAP Server].
5.
Check that [Program / Change] is selected.
6.
Select the LDAP server you want to program or change.
When programming the server, select [*Not Programmed].
7.
Press [Change] under "Name".
8.
Enter the name, and then press [OK].
9.
Press [Change] under "Server Name".
10.
Enter the server name, and then press [OK].
11.
Press [Change] under "Search Base".
Select a route folder to start the search from user codes registered in the selected folder are search
targets.
Programming the LDAP server
2
57
Advertisement
Table of Contents
