Table of Contents
Advertisement
Staple Position
Specify which Top 2 staples or Bottom shown on the initial display with priority.
The optional finisher or the booklet finisher is required to use this function.
The default setting for "Staple Position 1" is Top 1.
The default setting for "Staple Position 2" is Center.
The default setting for "Staple Position 3" is Left 2.
The default setting for "Staple Position 4" is Top 2.
The default setting for "Staple Position 5" is Bottom 1.
The default setting for "Staple Position 6" is Slant.
The default setting for "Staple Position 7" is Top Right 1.
The default setting for "Staple Position 8" is Right 2.
Punch Type
Specify which punch type (2 holes or 4 holes) has priority to be shown on the initial display.
The optional finisher is required to use this function.
The default setting for "Punch Type 1" is 2 Holes Left.
The default setting for "Punch Type 2" is 2 Holes Top.
The default setting for "Punch Type 3" is 2 Holes Right.
The default setting for "Punch Type 4" is 3 Holes Left.
The default setting for "Punch Type 5" is 3 Holes Top.
The default setting for "Punch Type 6" is 3 Holes Right.
Finisher: Staple Position
Specify the stapling position.
The optional finisher or the booklet finisher is required to use this function.
The default setting for "Finisher: Staple Position Type 1" is Top 1.
The default setting for "Finisher: Staple Position Type 2" is Center.
The default setting for "Finisher: Staple Position Type 3" is Left 2.
The default setting for "Finisher: Staple Position Type 4" is Top 2.
The default setting for "Finisher: Staple Position Type 5" is Bottom 1.
The default setting for "Finisher: Staple Position Type 6" is Slant.
The default setting for "Finisher: Staple Position Type 7" is Top Right 1.
The default setting for "Finisher: Staple Position Type 8" is Right 2.
Finisher: Punch Type
Specify the punch type.
Input/Output
4
101
Advertisement
Table of Contents
