Table of Contents
Advertisement
Paper Thickness:
The paper thicknesses you can set for Tray 7 (utilizing the Multi Bypass Tray) are as follows:
• Thin Paper
2
(60-75 g/m
)
• Plain Paper
2
(76-100 g/m
• Middle Thick
(101-126 g/m
• Thick Paper 1
(127-156 g/m
• Thick Paper 2
(157-220 g/m
The default setting for "Paper Type" is No Display.
The default setting for "Paper Thickness" is Plain Paper.
The default setting for "Apply Duplex" is Yes.
The default setting for "Apply Auto Paper Select" is Yes.
The key mark is displayed next to the paper tray if [No] is selected in [Apply Auto Paper Select].
Auto Paper Select can only be selected for the copier function if [No Display] and [Recycled Paper]
are selected. If [No] is selected, Auto Paper Select is not valid.
For details about the relations between possible paper sizes and thickness, see "Recommended Paper
Sizes and Types", About This Machine.
For details about the recommended conditions for using thick paper, see "Thick Paper", About This
Machine.
The optional tab sheet holder is required when using tab stock in Tray 7.
The number of tab stock shifts can be set in millimeters, when Tab Stock has been selected.
The number of tab stock shift can be set in 1 millimeter (1 inch) units, within a range of 0 to 15 mm
(0" to 0.6"). The default is 13 mm (0.5").
Designation Sheet 1 - 9:
You can specify and display the paper tray to set designation sheets. You can also specify the display
time and copying method for two sided copying.
• Display Time
You can select [At Mode Selected] or [Full Time].
• Apply Duplex
You can select [Yes] or [No].
)
2
)
2
)
2
)
Tray Paper Settings
3
75
Advertisement
Table of Contents
