Table of Contents
Advertisement
3. Tray Paper Settings
No Display, Recycled Paper, Color Paper 1, Color Paper 2, Yellow, Green, Blue, Purple, Ivory,
Orange, Pink, Red, Gray, Letterhead, Label Paper, Preprinted Paper, Bond Paper, Card Stock,
Prepunched Paper, Special Paper 1, Special Paper 2, Special Paper 3, Special Paper 4, Special
Paper 5, Special Paper 6, Envelope, Coated Paper 1, Coated Paper 2, Coated Paper 3, Tab Stock
Paper Thickness:
The paper thicknesses you can set for the Paper Tray 3 and 4 are as follows:
• Thin Paper
(60-75 g/m
3
• Plain Paper
(76-100 g/m
• Middle Thick
(101-126 g/m
• Thick Paper 1
(127-156 g/m
• Thick Paper 2
(157-220 g/m
• Thick Paper 3
(221-300 g/m
The default setting for "Paper Type" is No Display.
The default setting for "Paper Thickness" is Plain Paper.
The default setting for "Apply Duplex" is Yes.
The default setting for "Apply Auto Paper Select" is Yes.
The key mark is displayed next to the paper tray if [No] is selected in [Auto Paper Select].
Auto Paper Select can only be selected for the copier function if [No Display] and [Recycled Paper]
are selected. If [No] is selected, Auto Paper Select is not valid.
For details about the relations between possible paper sizes and thickness, see "Recommended Paper
Sizes and Types", About This Machine.
For details about the recommended conditions for using thick paper, see "Thick Paper", About This
Machine.
The optional tab sheet holder is required when using tab stock in Tray 3 or 4.
The number of tab stock shifts can be set in millimeters, when Tab Stock has been selected.
The number of tab stock shift can be set in 1 millimeter (1 inch) units, within a range of 0 to 15 mm
(0" to 0.6"). The default is 13 mm (0.5").
70
2
)
2
)
2
)
2
)
2
)
2
)
Advertisement
Table of Contents
