◆ Digital Operator and Front Cover
Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.
Note: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged into the
drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front cover
back into place before reattaching the digital operator.
Removing/Reattaching the Digital Operator
■
Removing the Digital Operator
While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it
from the drive.
Figure 14
Reattaching the Digital Operator
Insert the digital operator into the opening in the top cover while aligning it with the notches on the left side of the
opening.
Next, press gently on the right side of the operator until it clicks into place.
Figure 15
Removing/Reattaching the Front Cover
■
Removing the Front Cover
Models CIMR- LU20008 to 20075, 40005 to 40039, and 50003 to 50027
After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover (model
CIMR-LU20047, 40024, 40031, 50017, and 50022 does not use a screw to affix the front cover). Pinch
inwards on the tabs found on each side of the front cover, then pull forward to remove it from the drive.
Figure 16
Figure 16 Remove the Front Cover (Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027)
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Figure 14 Removing the Digital Operator
Figure 15 Reattaching the Digital Operator
3 Electrical Installation
YEA_common
YEA_common
YEA_common
3
31