Cisco ASA 5505 Configuration Manual page 1210

Configuring Failover with the High Availability and Scalability Wizard
(Not available on the ASA 5505 adaptive security appliance) Define the Stateful Failover link in the State
Step 6
Link Configuration screen.
See
Add standby addresses to the adaptive security appliance interfaces in the Standby Address
Step 7
Configuration screen.
See
Step 8 Review your configuration in the Summary screen. If necessary, click Back to return to a previous screen
and make changes.
See
Step 9 Click Finish.
The failover configuration is sent to the adaptive security appliance and to the failover peer.
Configuring Active/Standby Failover with the High Availability and Scalability
Wizard
The following procedure provides a high-level overview for configuring Active/Standby failover using
the High Availability and Scalability Wizard. Each step in the procedure corresponds to a wizard screen.
Click Next after completing each step, except for the last one, before proceeding to the next step. Each
step also includes a reference to additional information that you may need to complete the step.
In the Configuration Type screen, click Configure Active/Standby failover.
Step 1
See
Enter the IP address of the failover peer on the Failover Peer Connectivity and Compatibility Check
Step 2
screen. Click Test Compatibility. You cannot move to the next screen until all compatibility tests have
been passed.
See
screen.
Define the Failover Link in the Failover Link Configuration screen.
Step 3
See
(Not available on the ASA 5505 adaptive security appliance) Define the Stateful Failover link in the State
Step 4
Link Configuration screen.
See
Add standby addresses to the adaptive security appliance interfaces in the Standby Address
Step 5
Configuration screen.
See
Review your configuration in the Summary screen. If necessary, click Back to go to a previous screen
Step 6
and make changes.
See
Click Finish.
Step 7
Cisco ASA 5500 Series Configuration Guide using ASDM
58-4
State Link Configuration, page 58-7
Standby Address Configuration, page 58-8
Summary, page 58-9 for more information about this screen.
Configuration Type, page 58-5
Failover Peer Connectivity and Compatibility Check, page 58-6
Failover Link Configuration, page 58-7
State Link Configuration, page 58-7
Standby Address Configuration, page 58-8
Summary, page 58-9 for more information about this screen.
Chapter 58
for more information about this screen.
for more information about this screen.
for more information about this screen.
for more information about this screen.
for more information about this screen.
for more information about this screen.
Using the High Availability and Scalability Wizard
for more information about this
OL-20339-01