Cisco ASA 5505 Configuration Manual page 1370

Configuring AnyConnect Secure Mobility
Configuring AnyConnect Secure Mobility
AnyConnect Secure Mobility protects corporate interests and assets from Internet threats when
employees are mobile. Use the Mobile User Security dialog box to configure this feature. AnyConnect
Secure Mobility lets Cisco IronPort S-Series Web Security appliances scan Cisco AnyConnect secure
mobility clients to ensure that clients are protected from malicious software and/or inappropriate sites.
The client periodically checks to ensure that Cisco IronPort S-Series Web Security appliance protection
is enabled.
To configure secure mobility solutions, choose Configuration > Remote Access VPN > Network
(Client) Access > Mobile User Security.
Note
Figure 64-6
Fields
•
•
Cisco ASA 5500 Series Configuration Guide using ASDM
64-60
This feature requires a release of the Cisco IronPort Web Security appliance that provides
AnyConnect Secure Mobility licensing support for the Cisco AnyConnect secure mobility client.
It also requires an AnyConnect release that supports the AnyConnect Secure Mobility feature.
Mobile User Security Window
Service Access Control—Specifies from which host or network address the WSAs can
communicate.
Add—Opens the Add MUS Access Control Configuration dialog box for the selected
–
connection.
Edit—Opens the Edit MUS Access Control Configuration dialog box for the selected
–
connection.
Delete—Removes the selected connection from the table. There is no confirmation or undo.
–
Enable Mobile User Security Service—Starts the connection with the client through the VPN. If
enabled, you are required to enter a password, used by the WSA when contacting the ASA. If no
WSA is present, the status is disabled.
Chapter 64 General VPN Setup
OL-20339-01