Chapter 37
Configuring Inspection of Basic Internet Protocols
Modes
The following table shows the modes in which this feature is available:
Firewall Mode
Routed
•
NetBIOS Inspect Map
The NetBIOS Inspect Map dialog box is accessible as follows:
Configuration > Global Objects > Inspect Maps > NetBIOS
The NetBIOS pane lets you view previously configured NetBIOS application inspection maps. A
NetBIOS map lets you change the default configuration values used for NetBIOS application inspection.
NetBIOS application inspection performs NAT for the embedded IP address in the NetBIOS name
service packets and NetBIOS datagram services packets. It also enforces protocol conformance,
checking the various count and length fields for consistency.
Fields
•
•
•
•
Modes
The following table shows the modes in which this feature is available:
Firewall Mode
Routed
•
Add/Edit NetBIOS Policy Map
The Add/Edit NetBIOS Policy Map dialog box is accessible as follows:
Configuration > Global Objects > Inspect Maps > NetBIOS > NetBIOS Inspect Map > View
The Add/Edit NetBIOS Policy Map pane lets you configure the protocol violation settings for NetBIOS
application inspection maps.
Fields
•
OL-20339-01
Security Context
Transparent Single
•
•
NetBIOS Inspect Maps—Table that lists the defined NetBIOS inspect maps.
Add—Configures a new NetBIOS inspect map.
Edit—Edits the selected NetBIOS entry in the NetBIOS Inspect Maps table.
Delete—Deletes the inspect map selected in the NetBIOS Inspect Maps table.
Security Context
Transparent Single
•
•
Name—When adding a NetBIOS map, enter the name of the NetBIOS map. When editing an
NetBIOS map, the name of the previously configured NetBIOS map is shown.
Multiple
Context
System
•
—
Multiple
Context
System
•
—
Cisco ASA 5500 Series Configuration Guide using ASDM
NetBIOS Inspection
37-49