Common Problems
Symptom
Possible Cause
same security level.
Recommended Action
Level Communication" section on page
Symptom
Possible Cause
instead of 1000.
Recommended Action
Cisco ASA 5500 Series Configuration Guide using ASDM
76-14
Traffic does not pass between two interfaces on the same security level.
You did not enable the feature that allows traffic to pass between interfaces at the
Enable this feature according to the instructions in
IPSec tunnels do not duplicate during a failover to the standby device.
The switch port that the adaptive security appliance is plugged into is set to 10/100
Set the switch port that the adaptive security appliance is plugged into to 1000.
8-31.
Chapter 76
Troubleshooting
"Allowing Same Security
OL-20339-01