Cisco ASA 5505 Configuration Manual page 1133

Chapter 53 Managing SSMs and SSCs
In the Management Interface area, do the following:
Step 2
Choose the Interface VLAN from the drop-down list.
a.
This setting allows you to manage the SSC using this VLAN.
Note
Enter the IP address.
b.
Choose the subnet mask from the drop-down list.
c.
Enter the default gateway IP address.
d.
If the management station is on a directly-connected adaptive security appliance network, then set
the gateway to be the ASA 5505 VLAN interface address. If the management station is on a remote
network, then set the gateway to the address of an upstream router on the management VLAN.
In the Management Access List area, do the following.
Step 3
Note
a. Enter the IP address for the host network.
Choose the subnet mask from the drop-down list.
b.
Click Add to add these settings to the Allowed Hosts/Networks list.
c.
Note
d. To delete these settings, in the ASDM main window, click the IPS tab. Choose Configuration > IPS
> Sensor Setup > Allowed Hosts/Networks. Choose the host or network that you want to remove
from the list, and click Delete. To add new management settings, you can either click Add in the
existing pane or return to the SSC Setup pane by choosing Configuration > Device Setup > SSC
Setup.
In the IPS Password area, do the following:
Step 4
Note
Enter the password. The default password is "cisco."
a.
Enter the new password, and confirm the change.
b.
Click Apply to save the settings to the running configuration.
Step 5
The SSC Setup completed dialog box appears only after the initial configuration.
To complete the SSC application configuration and have ASDM go directly to the Configuration > IPS
Step 6
> Sensor Setup > Startup Wizard screen, do one of the following:
Click the IPS button in the navigation pane.
•
OL-20339-01
The following settings are written to the SSC application configuration, not the adaptive security
appliance configuration.
The following settings are written to the SSC application configuration, not the adaptive security
appliance configuration.
After you click Add, make sure you save the management settings you have just defined by
clicking Apply. If you decide to remove these settings, continue to the next substep.
Otherwise, go to Step
The following settings are written to the SSC application configuration, not the adaptive security
appliance configuration.
4.
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuring the SSC Management Interface
53-5