Cisco ASA 5505 Configuration Manual page 1628

Configuring Logging
Including the Date and Time in Syslog Messages
To include the date and time in syslog messages, perform the following steps:
Path
Configuration > Device Management > Logging > Syslog
Setup
Disabling a Syslog Message
To disable a specified syslog message, perform the following steps:
Path
Configuration > Device Management > Logging > Syslog
Setup
Changing the Severity Level of a Syslog Message
To change the severity level of a syslog message, perform the following steps:
Path
Configuration > Device Management > Logging > Syslog
Setup
Limiting the Rate of Syslog Message Generation
To limit the rate of syslog message generation, perform the following steps:
Choose Configuration > Device Management > Logging > Rate Limit.
Step 1
Choose the logging level (message severity level) to which you want to assign rate limits. Severity levels
Step 2
are defined as follows:
Cisco ASA 5500 Series Configuration Guide using ASDM
71-20
Description Severity Level
Emergency 0—System is unusable
Alert 1—Immediate action is needed
Critical 2—Critical conditions
Error 3—Error conditions
Warning 4—Warning conditions
Notification 5—Normal but significant conditions
Purpose
Specifies that syslog messages should include the date and
time that they were generated.
Purpose
Prevents the adaptive security appliance from generating a
particular syslog message.
Purpose
Specifies the severity level of a syslog message.
Chapter 71 Configuring Logging
OL-20339-01