Caller Id Name Set - Panasonic KX-TD816 Programming Manual

2.2 System Programming

[111] Caller ID Name Set

Description
With Caller ID Service, the calling party is displayed either by its ID Code or by its name. If
the name display is required, use this programme to give a name to a caller ID Code stored in
programme [110] Caller ID Code Set.
Selection
• Location number: 001 through 500
• Caller ID Name: 15 characters (max.)
Default
All locations – Not stored
Programming
1.
Enter 111.
Display: 111 CALLER NAME
2.
Press NEXT.
Display: Location NO?
3.
Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: 001:Not Stored
4.
Enter a Caller ID Name.
For entering characters, see Section 1.4 Entering Characters.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new name.
5.
Press STORE.
6.
To programme another location, press NEXT or PREV, or SELECT and the desired
location number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• Caller ID Name corresponds to the Caller ID Codes stored in programme [110] Caller ID
Code Set.
Features Guide References
Caller ID
72 General Programming