Smdr Format - Panasonic KX-TD816 Programming Manual

2.8 Resource Programming

[801] SMDR Format

Description
Used to match the SMDR output to the paper size being used in the printer. Page length
determines the number of lines per page. Skip perforation determines the number of lines to be
skipped at the end of every page.
Selection
• Page length (lines): 4 through 99
• Skip perforation (lines): 0 through 95
Default
Page length – 66; Skip perforation – 0
Programming
1.
Enter 801.
Display: 801 SMDR FORMAT
2.
Press NEXT to programme page length.
Display example: Page Length:66
3.
Enter the page length.
To change the current entry, press CLEAR and enter the new page length.
4.
Press STORE.
5.
Press NEXT to programme skip perforation.
Display example: Skip Perf: 0
6.
Enter the skip perforation.
To change the current entry, press CLEAR and enter the new skip perforation.
7.
Press STORE.
8.
Press END.
Conditions
• The page length should be four lines or more longer than the skip perforation length.
• A title is positioned on the first three lines on every page.
• The programmed format becomes valid only if the Serial Interface (RS-232C) cable is
connected. If a printer is already connected, disconnect it and connect again. Otherwise the
former format becomes valid.
Features Guide References
Station Message Detail Recording (SMDR)
264 General Programming