Outside-To-Tie Transfer - Panasonic KX-TD816 Programming Manual

[436] Outside-to-TIE Transfer

Description
Enables or disables transferring an incoming outside call to the TIE line on an outside line
group basis. This restriction applies to the following: 1) A TIE call using DISA 2) Call
Forwarding to a TIE line 3) Call Transfer to a TIE line.
Selection
• Outside line group (TRG) number: 1 through 8,
• Enable / Disable
Default
All outside line groups – Disable
Programming
1.
Enter 436.
Display: 436 CO-TIE XFER
2.
Press NEXT.
Display: TRK GRP NO?
3.
Enter an outside line group number.
To enter outside line group number 1, you can also press NEXT.
Display example: TRG1:Disable
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To programme another outside line group, press NEXT or PREV, or SELECT and the
desired outside line group number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
To assign all outside line groups to the same selection, press the
the display shows the contents programmed for outside line group number 1.
Features Guide References
TIE Line Service
General Programming
2.5 Outside Line Programming
( =all outside line groups)
key in step 3. In this case,
207